Posted on 04/21/2022 11:46:36 AM PDT by RomanSoldier19
I thought it was an entire Special Forces division composed exclusively of trans-men.
ANY gun is only as accurate as it’s handler.
Probably a way for the weapons manufacturers to make a crap load of money. After 100s of years of killing each other the 5.56 with the 7.62 as automatic is plenty sufficient as proven.
I remember I used to have a 22 mag in bolt action. We were shooting at empty cereal boxes over those this iron “T” barbed wire fence posts.
When we were done I was surprised that several rounds had actually hit the posts and bent them deeply even with small penetration holes in the center. I guess those are 1/4 to 1/3 inch thick. A 5.56 has what… 4 times the energy of a 22 mag?
Just think of the money they will make by having the USA and most of the west rearm.
5.56/223
Is Obsolete now.
The future of “rifles” will be the .50 cal EXACTO smoothbore laser-guided round.
https://en.wikipedia.org/wiki/EXACTO
Did you have a Sonic Blaster? I still want one, but I can’t afford it.
Body armor.
Big Army is re-tooling in anticipation of an era when everybody on the battlefield will be wearing body armor. The poodle-shooter 5.56's projectiles are too low in mass to meet the requirements for defeating body armor. Which is precisely why Sig felt the need to think outside the box and redefine what "high pressure" is.
This round from a 16" barrel produces near as makes no difference identical muzzle energy to a 175-grain 7.62x51 NATO round from a 24" barrel.
And with armor-piercing projectiles, it will defeat all known body armors as well as any known to be in development.
Which was why I posted my #36 :(
More lethal…does that mean deader than dead?
“Which is precisely why Sig felt the need to think outside the box and redefine what “high pressure” is.”
U.S. Army spec’d.
5.56: For when you want to reach out and touch someone.
6.8x51: For when you want to reach out and whack someone.
Made in NH.
Bad is one.
Damned if that didn’t trigger my mask reflux.
80,000 PSI?? Damn! Even the suppressor will need to be a bit stout.
Don’t see much reloading potential.
..and such corrosion will lead to head failure from high pressure rounds and the extractor breaking the cartridge rim.
I’m gonna go build one. One that shoots around corners and through walls and stuff.
I like it.
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.