You can use a non-scented, household chlorine bleach that contains a chlorine compound to disinfect water.
Do not use non-chlorine bleach to disinfect water. Typically, household chlorine bleaches will be 5.25% available chlorine. Follow the procedure written on the label. When the necessary procedure is not given, find the percentage of available chlorine on the label and use the information in the following table as a guide. (Remember, 1/8 teaspoon and 8 drops are about the same quantity.)
Available Chlorine Drops per Quart/Gallon of Clear Water Drops per Liter of Clear Water
1% 10 per Quart - 40 per Gallon 10 per Liter
4-6% 2 per Quart - 8 per Gallon (1/8 teaspoon) 2 per Liter
7-10% 1 per Quart - 4 per Gallon 1 per Liter
(If the strength of the bleach is unknown, add ten drops per quart or liter of filtered and settled water. Double the amount of chlorine for cloudy, murky or colored water or water that is extremely cold.)
Mix the treated water thoroughly and allow it to stand, preferably covered, for 30 minutes. The water should have a slight chlorine odor. If not, repeat the dosage and allow the water to stand for an additional 15 minutes. If the treated water has too strong a chlorine taste, allow the water to stand exposed to the air for a few hours or pour it from one clean container to another several times.
You can use granular calcium hypochlorite to disinfect water.
Add and dissolve one heaping teaspoon of high-test granular calcium hypochlorite (approximately ¼ ounce) for each two gallons of water, or 5 milliliters (approximately 7 grams) per 7.5 liters of water. The mixture will produce a stock chlorine solution of approximately 500 milligrams per liter, since the calcium hypochlorite has available chlorine equal to 70 percent of its weight. To disinfect water, add the chlorine solution in the ratio of one part of chlorine solution to each 100 parts of water to be treated. This is roughly equal to adding 1 pint (16 ounces) of stock chlorine to each 12.5 gallons of water or (approximately ½ liter to 50 liters of water) to be disinfected. To remove any objectionable chlorine odor, aerate the disinfected water by pouring it back and forth from one clean container to another.
From EPA
http://water.epa.gov/drink/emerprep/emergencydisinfection.cfm
Don’t forget “trichlor” pool shock.
In the quantities I bought it in (to share with others when TSHTF), I could purify millions of gallons.
I think the ratio is 1/8th teaspoon per 50 gals for purification purposes.
This stuff is dangerous, though. Larger ratios will cause some explosive effects.
Thank you so much for your response. I don’t have a lot of money to do everything I need to do but I certainly can do a few things like clean drinking water thanks to all the advice I have received.