As far as I know, 5.56 is the military designation for .223. I have a 308 and have purchased 7.62 military ammo.
I haven’t unboxed my reloading equipement or books since moving about 10 years ago but I am quite certain that there is no difference.
Dimensionally there's not hardly a difference.
But there are other considerations.
While the 5.56 mm and .223 cartridges are very similar, they are not identical. Military cases are made from thicker brass than commercial cases, which reduces the powder capacity (an important consideration for handloaders)[6], and the NATO specification allows a higher chamber pressure. Test barrels made for 5.56 mm NATO measure chamber pressure at the case mouth, as opposed to the SAAMI location. This difference accounts for upwards of 20,000+ psi difference in pressure measurements. That means that advertised pressure of 58,000 psi for 5.56 mm NATO, is around 78,000 psi tested in .223 Rem test barrels (SAAMI .223 Rem Proof MAP is 78,500 psi so every 5.56 mm round fired is a proof load, very dangerous). The 5.56 mm chambering, known as a NATO or mil-spec chambers, have a longer leade, which is the distance between the mouth of the cartridge and the point at which the rifling engages the bullet. The .223 chambering, known as the "SAAMI chamber", is allowed to have a shorter leade, and is only required to be proof tested to the lower SAAMI chamber pressure. To address these issues, various proprietary chambers exist, such as the Wylde chamber[7] or the Armalite chamber, which are designed to handle both 5.56 mm and .223 equally well. These 5.56x45mm NATO cartridges are identical in appearance to .223 Remington. They are, however, not completely interchangeable.Using commercial .223 cartridges in a 5.56-chambered rifle should work reliably, but generally will not be as accurate as when fired from a .223-chambered gun due to the excessive lead. [8] Using 5.56 mil-spec cartridges (such as the M855) in a .223-chambered rifle can lead to excessive wear and stress on the rifle and may even be unsafe, and SAAMI recommends against the practice.[9] Some commercial rifles marked as ".223 Remington" are in fact suited for 5.56 mm, such as many commercial AR-15 variants and the Ruger Mini-14[10], but the manufacturer should always be consulted to verify that this is acceptable before attempting it, and signs of excessive pressure (such as flattening or gas staining of the primers) should be looked for in the initial testing with 5.56 mm ammunition.
Doc,
A small correction:
Using .223 in a 5.56 chamber is quite safe as the 5.56 chamber has a longer leade than the .223. Using 5.56 is a .223 chamber MAY cause excessive chamber pressures due to bullet shape and OAL. Most manufacturers recommend against this practice.
Haven’t researched the 7.62 and .308 issue so will not comment until I do.