Posted on 07/15/2005 10:14:34 PM PDT by Lexinom
A very strange thing happened this week.
I use two almost identical laptops in my home office, a HP Pavilion, and a Compaq Presario 2500. Each runs Windows XP - one Home, one Professional. Both are net-connected through their built-in wireless adapters via the NetGear router. Both have worked fine until earlier this week.
This evening my wife and I went out to Office Depot to purchase a new router. Obviously, the NetGear router had failed. This had happened with the previous wireless router (a generic brand) which lasted a year.
We got home and set up the new LinkSys router. I configured all the settings peculiar to our network schema and achieved wired connectivity. I set up the wireless settings too - WEP encryption with a passphrase and key, which channel to use.
From the laptop, I got the same behavior as with the old netgear router: "One or more wireless networks are availble". Click connect. "Connected to network. Signal strength Excellent". All well and good except for one thing...
In the bottom right corner of the screen, in the System Tray, is an icon consisting of two monitor images - one representing the remote network peer, and one representing the client. NEVER, EVER, does the backside one light up... Even though I'm connected with strong signal! I played with channels settings, changed the LinkSys operating mode from Router to Gateway. Nothing. Set static IPs for the client. Nothing. Played with the more esoteric advanced settings on the LinkSys. Nothing.
In short, the behavior matched - indentically! - that seen using the old NetGear.
I can only conclude that both of my laptop network cards have failed at exactly the same time.
Theories
1. A strong electromagetic event near the house, sort of like a mini-EMP, took them out (they are delicate circuits, after all).
2. Some sort of cosmic event, perhaps causing (1).
3. Heat? This seems doubtful, considering they failed at the same time.
4. I think the most plausible explanation is the NetGear router IS bad, and during thermal runaway of the driver transistor (as it was burning but still operational) sent a carrier signal so strong it burned out the wireless adapters. I've heard this is possible with other types of radio ways but have never experienced it.
My inclination is to leave the new LinkSys Router in place and purchase a new WiFi adapter for each laptop.
Have there been any nuclear detonations near your home recently?
Not above ground :-)
This approach invariably works for me.
Which Linksys is it?
It is a "WRT54G Wireless-G Broadband Router", brand new.
Can you ping the router from one of the laptops?
3RD POSSIBILITY.
Interference. Neighbor bought a wireless router or phone and is interrupting your signal.
Use Netstumbler on your laptops. It will show if a neighbor is interfering.
It wont show a 2.4 phone though.
BTW the wireless mode on the router is set to "b" (not "g"). This is the older mode, and does allow connection to the wireless network as reported by client.
Good suggestion though.
Netstumbler? I will give that a shot. Thanks.
Stuff breaks down.... DLINK is better than LINKSYS.
Did you change the IP address of the router? IOW, double-check that you're pinging the right addy ;)
Early this week the two laptops were stacked one on top of the other. I was using the top one. The harddrive hiccupped, and I thought it was gone (it probably does need to be replaced). It made a funny clicking noise and then stopped. Everything froze, incl. the mouse cursor. I did a hard power-cycle. After the "HP" screen (built into the BIOS), the screen displayed "Operating system not found."
My theory: If the hard drive, spinning at 5400 RPM, were to suddenly stop for some reason (as sounded like happened), the magnetic pulse from the motor would send a sudden shockwave of induced current into the wiring of the WIFI cards, located immediately below the hard-drives. Since the machines were stacked, it would have penetrated outward to the lower machine as well, apparently with enough strength to cause damage to the transmission circuitry. A "mini-EMP".
Incidently, though I assumed that HD was toast, I am using that very machine at this moment to type this message with the same HD.
Yeah, it's 192.168.1.1. That's the address I had used earlier to configure it. I really do think the WIFI cards are toast - no evidence of transmission of any sort, only picking up the SSID broadcast from the network called "linksys".
Thanks alot. I laughed and woke up the wife. =)
Bought mine from the IP. Under warranty as long as I have service with them.
Far more likely, you're experiencing a network config issue with your laptops.
I would suggest that you erase your current network settings on one laptop, and reconfigure the laptop's network settings. You can probably start by directly connecting the laptop via ethernet to make sure the router is routing traffic via the ethernet.
After that, attempt to set up the wireless again.
Did you manually enter the DNS servers addresses on the laptops? Try a static IP like http://209.157.64.200/
The simplest way to test the cards might be to either set up an ad-hoc peer-to-peer connection between them, and se if they can talk to each other, or take them to the local internet cafe/Starbucks/whatever, and spring for a few minutes of connectivity to test them. Or just "borrow" a neighbor's connection for a few minutes ;)
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.