Posted on 10/18/2008 7:57:42 AM PDT by linuxppcguy
Yeah, the Supremes are just working their way up to appointing the POTUS. No big deal.
Yes, that’s my recollection. I wonder if it’ll allow voters to import votes from a 5 1/4” floppy? :-)
Check out http://www.blackboxvoting.org/
The Z80 is a perfectly fine choice, actually. What's wrong with it?
IMHO, for a machine to be considered trustworthy it must be possible to confirm that the machine is running the official firmware and nothing else. Were I constructing a voting machine, it have no on-board non-volatile storage of any form other than a non-writable real-time clock chip, and would accept two cartridges:
Cartridges would be constructed with a visible write-protect switch whose state could only be changed by opening a panel. Both parties would supply their own seals for this panel. The cartridges could be read via simple USB-connected reader (could be profitably produced in quantity 1,000 for less than $50 each).
Protocol: firmware and cast-ballot cartridges should be set up before the election by the state election officials. All cartridges should have their write-protect switches set to "protect".
To start with, the firmware cartridge should be sealed by both parties. An election judge from each party should read out the contents of both cartridges and confirm that they precisely match the official standard image. All parties should watch all cartridge handling closely to ensure that the write-protect switch on the ballot cartridge is not moved. If someone thinks the ballot write-protect switch may have been moved by the other party, that person should re-read the cartridge to ensure that it has not been altered.
Once everyone is satisfied that the cartridges contain precisely what they should, they should be installed in the machine and the cover closed, but the switch to the processor left in the "unlocked" position. The firmware would then start up, prompt for the correct time, and store on the ballot cartridge the difference between the hardware clock time and the entered time. It would also display the status of the ballot cartridge which should be confirmed at that point as containing zero votes.
Once that is done, the switch would be moved to the "locked" position and padlocks would be installed. The system would then be ready for operation.
Once voting is complete, the padlocks would be removed and the switch set to the "unlocked" position. This would allow the totals to be read out from the machine. Next, the machine would be opened and the ballot cartridge write-protected and sealed. After that was done, both parties would read out both cartridges again. They would then compare SHA hash values for the two cartridges, exchange digital signatures, and a representative from each party would be video-recorded writing both the hash value and vote tallies on a chalkboard (the latter would be a protection against a party releasing its own private key and then accusing the other party of using that key to fake the records).
If units and cartridges were constructed in such a fashion as to facilitate X-rays of the chips involved, what room would there be for fraud?
Using ID numbers in this fashion would make the act of "write-in" voting faster and more convenient when using digital machines; it would also avoid any potential difficulties that could arise if there were votes cast for "John Smith", "John M. Smith", "John Martin Smith", and "John Mitchell Smith". What should happen if "John M. Smith" gets a majority? Or, for that matter, if "John Smith" gets a majority and some obscure person "John (no middle initial) Smith" steps forward and claims victory?
Using ID numbers for write-in votes would avoid this problem, since whatever candidate had been assigned the winning number would be the winner.
Lefties were pointing out the flaws of these voting “machines.”
bttt
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.