Free Republic
Browse · Search
General/Chat
Topics · Post Article

To: OKSooner
OK, I'm gonna run on mem here...

Put the bolt in the receiver, and assemble those onto the grip frame.

Take the mainspring housing, and shove the bolt stop pin up into place, until it seats.

Point the muzzle down towards the floor.

Swing the mainspring housing up towards the bolt, so you can see up inside the pistol.

Looking into the grip frame where the mainspring housing will go, you will see the hammer. Pull the trigger so the hammer swings forward via gravity.
You may have to give the pistol a shake away from you to get the hammer to drop forward. You'll hear it click. Release the trigger.

Still looking into the grip frame, rotate the muzzle upwards while watching the hammer strut, it will point down towards the floor.

Swing the mainspring housing into place. You will feel spring pressure the last quarter-inch as the mainspring pushes against the hammer strut.

Rotate the housing latch into place and dry fire to test.

Exploded view here. hope this helps, once you figure it out, you'll laugh. All this fol-de-rol takes less than ten seconds.

91 posted on 02/20/2015 10:17:56 AM PST by W. (Dem0crat-mandated education reform killed American progress. Thanks, morons!)
[ Post Reply | Private Reply | To 90 | View Replies ]


To: W.

Thanks again.


92 posted on 02/20/2015 11:33:03 AM PST by OKSooner ("Remember Fort Hood, Boston, and Moore, Oklahoma.")
[ Post Reply | Private Reply | To 91 | View Replies ]

To: W.

Keywords added...


93 posted on 02/20/2015 11:34:02 AM PST by OKSooner ("Remember Fort Hood, Boston, and Moore, Oklahoma.")
[ Post Reply | Private Reply | To 91 | View Replies ]

Free Republic
Browse · Search
General/Chat
Topics · Post Article


FreeRepublic, LLC, PO BOX 9771, FRESNO, CA 93794
FreeRepublic.com is powered by software copyright 2000-2008 John Robinson