Posted on 12/09/2005 10:49:04 AM PST by Travis McGee
I disagree with you on that one. The plywood sheets aren't carrying the full load above them. You can't see this easily because the labels are in the way, but each pallet has another vertical support running down the middle of it. So it looks as if there are only about 12 inches between each support -- which means these pallets are not the typical industrial pallets you see in a warehouse.
I get that at $500 per troy ounce that the gold would occupy about 111 cubic feet of gold or a 10X11 room stacked one foot deep.
(((1e9 / 500) / 12) * (373 / 453.6)) / 64) / 19.3 = 110.955096
Assuming 12 troy ounces to the troy pound
373 grams/troy pound
453.6 grams per regular pound
one cubic foot of water =64 pounds
the density of gold is 19.3 times as much as water
The risers on these pallets look like 2x4 instead of 1x4, and the top & bottom look like 1x? instead of half x ?.
IOW the pallets are stronger than normal. Strong enough not to collapse under 6 tons?
Na. I'd say around 35-40 lbs each. (I got to hold one a while back --- just couldn't figure out how to stuff it in my pocket without that damn guard noticing.)
"Typical gold bar is 400 troy ounces"
Working from that figure, I get that there should be 5000 bars
(1e9 / 500) / 400 = 5 000
Notice how the first layer on each pallet is laid with or along the slats of the pallet whereby subjecting it's mass mostly to the large timbers making up the web of the pallet. The compressive strength of this hardwood, most likely red oak, is impressive and certainly can take the loading. Pallets like these routinely handle bricks and are not as well built and often used more than once breaking down each time. Although gold is denser, and the pallet is heavier, it seems to me that this picture is plausible.
If this is the vault for Barclay's Bank GLD shares I wouldn't worry about it. Barclay's makes a hell of a lot more than a billion dollars a year on its iShares products.
Actually, with the load being so evenly distributed, the wood should hold up. If you notice the horizontal boards do show some deflection. I will run the numbers later to see if the mechanics equations bear the same results, but I'm pretty sure they will. I load 300 hp motors onto wood palets all the time and that is a force of 400 lbs only over 16 in^2.
The gold stored in the Depository at Ft. Knox is in the form of standard mint bars of almost pure gold or coin gold bars resulting from the melting of gold coins. These bars are about the size of an ordinary building brick, but are somewhat smaller. The approximate dimensions are 7 x 3-5/8 x 1-3/4 inches. The fine gold bars contain approximately 400 troy ounces of gold. The avoirdupois weight of the bars is about 27-1/2 pounds. They are stored in the vault compartments without wrappings.
The load is largely transmitted to the floor through the beams on the sides and center of the pallets.
This puts 1/3 the entire weight of the entire stack above directly onto that edge, where the horizontal plywood floor meets the vertical riser. (1/3, because 1/3 is on the center vertical riser, and one third is on the opposite side vertical riser.)
This reduces the entire problem to a simple sheer strength equation. 1/3 of the entire weight of the stack above that point, against that plywood, in sheer.
Would it hold, or would it fail?
We need to know the exact weight of the gold above, and the sheer strength of the plywood.
I think that data should be right in a civil engineering text book, if we can make assumptions about the horizontal wood's compression, tensile and sheer strength.
Can't say about the gold, but I sympathize about the lead. Doing radiation tests I once stacked 1500 lead bricks at 30 lbs per brick.
I'm not so sure about that, or what % of the load is transmitted through the side beams. Looks more like a sheer strength situation to me, as laid out in my last reply.
""I rough-count approx. 150 pallets in sight, with approx. 80 bars per pallet"
Then that's twice as many bars as they need @ $500/oz.
Based upon a previous post, there are 150 pallets with 80 bars at 100 lbs each equal 1,200,000 pounds of gold.
Your post indicates lbs to grams equal (1,200,000 X 453.6) is 544,320,000 grams. Grams to troy lbs divide 544,320,000 by 373 will give you 1,459,302.95 troy lbs. At 12 troy ounces to the lbs 1,459,302.95 troy lbs equal 17,511,635.39 troy ounces. At apporximately $500.00 per troy ounce, the value of the room is $8,755,817,695.35.
I don't care that it would crush the lower pallets. I just want a lot of trucks and forklifts.
I'm just guessing, but the ingots in the photos look longer than 7 inches long to me.
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.