Posted on 12/26/2011 10:45:07 PM PST by Kevmo
1) It looks like the air filter in my car but it also looks like an enormous heat sink.
2) Where is the three inches of lead shielding?
3) Rossi isn’t churning these out in his garage, someone had to make over a hundred of the cases and lids for the fat cat and it’s not a trivial task unless he’s stamping them out like an oil pan.
4) It doesn’t look like it could hold a lot of water if we assume the heat sink center block is solid.
5) The lid needs a lip like on an oil pan or it will expand between bolts.
6) It looks like he’s using gasket sealer instead of a gasket, bad idea in the long run but this is just a prototype.
That little box holds almost 8 gallons, that's hard to believe if you compare it to a car's gas tank. It's possible that if you include all the lines it might add up but those E-cats aren't that big and they aren't hollow, at least the one they showed isn't.
I don't recall whether they were allowed access to the interior during this particular test, but in the Oct. 18 "single fat E-cat" test, the E-cat was disassembled in the presence of the witnesses. That visual examination shows that the "core" is nowhere near 25 liters. And in the 18 October test the dimensions of the "core" are given as I stated previously.
Agreed.
Aussie Guy came to a screeching halt and the people on Vortex or Peak oil are po'd at his scams.
Aussie Guy came to a screeching halt and the people on Vortex or Peak oil are po'd at his scams.It's worth noting that Aussie Guy, if he really is Greg Watson, has used a "revolutionary new energy" scam to steal over $60 million from gullible investors.
His scam looked remarkably like what Rossi is doing, right down to claiming that he was building robotic factories to produce "millions" of units a year.
"1) It looks like the air filter in my car but it also looks like an enormous heat sink."
Yup.
"2) Where is the three inches of lead shielding?
"According to Rossi"...the ultimate "core" (in which resides the nickel nanopowder) is 20 cm by 20 cm by 2cm. The lead shielding consists of 2cm on all "faces", and the heat exchanger is "on top" of all that.
"3) Rossi isnt churning these out in his garage, someone had to make over a hundred of the cases and lids for the fat cat and its not a trivial task unless hes stamping them out like an oil pan."
This has been one of my major points ever since the 1MW system pictures showed up. A "hugh" amount of work is being done "somewhere" to put all this stuff together.
"4) It doesnt look like it could hold a lot of water if we assume the heat sink center block is solid."
See #1. There's probably quite a bit of volume between those heat-sink fins, which are on both top AND bottom of the "core".
"5) The lid needs a lip like on an oil pan or it will expand between bolts."
I hadn't noticed this detail.
"6) It looks like hes using gasket sealer instead of a gasket, bad idea in the long run but this is just a prototype."
Which prototype is probably assembled/disassembled multiple times. I think this is an argument "against" using a gasket sealer (or at least one that "sets up" like silicones do). He may be using a "grease" type that doesn't "cure" after assembly just for that reason.
Do you think there is enough room in there to hold 8 gallons?
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.