Kitchen sponge supercapacitor has many porous benefits

phys.org ^ | 02-06-2015 | by Lisa Zyga

[Red Badger]

By dipping small pieces of an ordinary kitchen sponge into solutions of nanoscale electrode materials, scientists have created a light-weight, low-cost supercapacitor that benefits from the sponge's porous structure. The pores provide a large surface area for the electrode materials to attach to, leading to an increase in ion movement between the electrodes and the electrolyte that fills in the pores. Overall, the new supercapacitor exhibits a performance that is superior to that of one made of the same electrode materials but without the sponge.

The researchers, led by Jun Ma at the University of South Australia, have published their paper on the kitchen sponge supercapacitors in a recent issue of Nanotechnology.

Although this is not the first time that sponges have been used to make supercapacitors, the idea is still new and not widely used. The study is the first to use sponges as the substrate for a composite of two particular electrode materials: 2-nm-thick graphene platelets, and nanorods made from the conducting polymer polyaniline (PANi). Each material has its own advantages and disadvantages, but when combined they offer the best of both worlds due to their synergetic effects. While the graphene platelets offer high power density but low capacity, the PANi nanorods offer a much higher capacity but suffer from a lower electrical conductivity and other drawbacks.

When combined, the two materials help to "correct" each other's weakness, in a sense. The graphene platelets consist of multiple layers, but usually not all of them are accessible to the electrolyte, which limits capacitance. When PANi nanorods are grown on the surface of the graphene platelets, they act as nanospacers to enlarge the interlayer distance between the platelets to make full use of their storage ability. On the other hand, the highly conductive graphene platelets improve the conductivity of the nanorods by wedging open the PANi fibers to provide more interface with the electrolyte.

"This work reports a novel design for the fabrication of supercapacitor electrodes by taking advantage of the synergy between cost-effective graphene plates, conducting polymers, and kitchen sponge electrodes, resulting in not only excellent capacitance and decent power and energy density, but high capacity retention over 12,000 cycles," Ma told Phys.org.

To demonstrate its performance, the researchers connected three of the supercapacitors to power a red LED for five minutes. They hope that this easily fabricated device could have applications where light-weight, low-cost energy storage devices are needed.

"The electrodes developed are flexible and have high performance, so they have many potential applications, especially for bendable, wearable, and portable electronics," Ma said.

Explore further: Energy storage of the future

More information: Mahmoud Moussa, et al. "High-performance supercapacitors using graphene/polyaniline composites deposited on kitchen sponge." Nanotechnology. DOI: 10.1088/0957-4484/26/7/075702

Journal reference: Nanotechnology

Read more at: http://phys.org/news/2015-02-kitchen-sponge-supercapacitor-porous-benefits.html#jCp

[Red Badger]

(Top left) The specific capacitances of several electrode materials. (Top right) Schematic diagram of ion transportation in a supercapacitor with and without the sponge. (Bottom left) Graph of the voltage and charge/discharge rates for single and tandem supercapacitors. (Bottom right) A three-unit cell is used to power a red LED. Credit: Moussa, et al. ©2015 IOP Publishing

Scanning electron microscope images of (a) a pure sponge, (b) sponge with graphene nanoplatelets, and (c) sponge with graphene nanoplatelets and PANi. Credit: Moussa, et al. ©2015 IOP Publishing

[Red Badger]

Battery & SUPERCapacitor Ping!.................

[ShadowAce]

[chrisser]

I guess this technology is “Sponge-worthy”.

[ctdonath2]

The “holy grail”: a lightweight ultracapacitor, a few cubic feet in size, able to run an electric car several hundred miles and recharge in a few minutes.

One problem with ultracapacitors: propensity to instant discharge if possible. Safety is a huge issue when capable of dumping 100kW/h thru someone in a millisecond.

[Dan(9698)]

If it has a reaction using electrolyte, It is a battery.

It may still be useful.

[wbill]

capable of dumping 100kW/h thru someone in a millisecond.

That's getting the short end of the stick. Resistance would be futile.

And yes, I've got no shortage of horrible puns. I should be grounded for it.

[Red Badger]

[Red Badger]

Resist we much!..............

[Red Badger]

They just discovered this.

The battery people at Firefly International Energy discovered this years ago.............

http://fireflyenergy.com/technology/firefly-technology/

[wbill]

I’m taking my puns and going ohm.

[chajin]

looks like a good idea, as farad it goes...

[ctdonath2]

It’s SO dangerous that even being deep underwater doesn’t stop the flames.

[OneWingedShark]

If it has a reaction using electrolyte, It is a battery.

You sure?

[MrB]

Boo!

[thackney]

From Caterpillar

http://fireflyinternationalenergy.com/wp-content/uploads/2013/04/Firefly_HistoryOfInnovation.pdf

[bunkerhill7]

I can`t comment on this as I am super-incapacitated at the moment.

[A Formerly Proud Canadian]

I’m taking my puns and going ohm.

Watts up with that?

[Red Badger]

Okay, you are discharged.............

[Red Badger]

Well, it’s current technology...............